Aquametrix 2200R ORP Analyzer/Controller User Manual Manuel d'utilisateur télécharger pdf (Page 8)

Model 2200R Page 6

3.5 Sensor Connections

3.5.1 Jumpers J42 are used to select which type of probe is being used. If a differential

probe (R60) is used, ensure that both J42 jumpers are in the up position. If a

combinational probe is used, ensure that both jumpers are in the down position.

(Refer to Fig. 2)

3.5 Probe Connections: DIFFERENTIAL PROBE (R60 SERIES)

3.5.1 Ensure that both J42 jumpers are in the up position, leaving the pins nearest to the

bottom exposed. Connect the 6 wires from the probe to the TB2 terminal strip on

the main circuit board. Match the colors of the probe wires to the terminals marked

on the circuit board. (Refer to Fig. 3)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Pas de commentaire

Aquametrix 2200R ORP Analyzer/Controller User Manual Manuel d'utilisateur Page 8